Symetrix Zone Mix 761 User Manual download pdf

QUICK START GUIDE: Zone Mix 761

Safety

G The lightning ﬂash with arrowhead

symbol within an equilateral triangle is

intended to alert the user of the presence

of uninsulated “dangerous voltage”

within the product’s enclosure that may

be of sufﬁcient magnitude to constitute

a risk of electric shock to persons. The

exclamation point within an equilateral

triangle is intended to alert the user of

the presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the product (i.e.

this Quick Start Guide).

G CAUTION: To prevent electric shock,

do not use the polarized plug supplied

with the device with any extension cord,

receptacle, or other outlet unless the

prongs can be fully inserted.

G Power Source: This Symetrix hardware

uses a universal input supply that

automatically adjusts to the applied

voltage. Ensure that your AC mains

voltage is somewhere between 100-240

VAC, 50-60 Hz. Use only the power

cord and connector speciﬁed for the

product and your operating locale. A

protective ground connection, by way of

the grounding conductor in the power

cord, is essential for safe operation. The

appliance inlet and coupler shall remain

readily operable once the apparatus has

been installed.

G Lithium Battery Caution: Observe the

correct polarity when changing the lithium

battery. There is a danger of explosion if

battery is incorrectly replaced. Replace

only with the same or equivalent type.

Dispose of used batteries according to

local disposal requirements.

G User Serviceable Parts: There are no

user serviceable parts inside this Symetrix

product. In case of failure, customers

inside the U.S. should refer all servicing to

the Symetrix factory. Customers outside

the U.S. should refer all servicing to an

authorized Symetrix distributor. Distributor

contact information is available online at:

http://www.symetrix.co.

"7*4

/&1"40673*3

*MOFTFUSPVWFBMJOUFSJFVSBVDVOFQJFDFQPVSWBOUFOUSFSFQBSÊFMVTBHFS

4&&08/&34."/6"-70*3$")*&3%*/4536$5*0/4

4BESFTTFSBVOSFQBSBUFVSDPNQÊUFOU

3*426&%&$)0$&-&$53*26&

/PVTFSTFSWJDFBCMFQBSUTJOTJEF3FGFSTFSWJDJOHUPRVBMJGJFETFSWJDFQFSTPOOFM

$"65*0/

8"3/*/(

503&%6$&5)&3*4,0''*3&03

&-&$53*$4)0$,%0/05&9104&

5)*4&26*1.&/5503"*/03.0*4563&

%0/0501&/

3*4,0'&-&$53*$4)0$,

Important Safety

Instructions

! Read these instructions.

@ Keep these instructions.

# Heed all warnings.

$ Follow all instructions.

% Do not use this apparatus near water.

This apparatus shall not be exposed to

dripping or splashing and no objects

ﬁlled with liquids, such as vases, shall be

placed on the apparatus.

^ Clean only with dry cloth.

& Do not block any ventilation openings.

Install only in accordance with the

manufacturer’s instructions.

* Do not install near any heat sources such

as radiators, heat registers, stoves, or

other apparatus (including ampliﬁers) that

produce heat.

( This apparatus shall be connected to

a mains socket outlet with a protective

earthing connection. Do not defeat

the safety purpose of the polarized or

grounding-type plug. A polarized plug has

two blades with one wider than the other.

A grounding type plug has two blades

and a third grounding prong. The wide

blade or the third prong are provided for

your safety. If the provided plug does not

ﬁt into your outlet, consult an electrician

for replacement of the obsolete outlet.

BL Protect the power cord from being

walked on or pinched particularly at

plugs, convenience receptacles, and the

point where they exit from the apparatus.

BM Only use attachments/accessories

speciﬁed by the manufacturer.

BN Use only with the cart, stand,

tripod, bracket, or table

speciﬁed by the manufacturer,

or sold with the apparatus.

When a cart is used, use

caution when moving the cart/apparatus

combination to avoid injury from tip-over.

BO Unplug this apparatus during lightning

storms or when unused for long periods

of time.

BP Refer all servicing to qualiﬁed service

personnel. Servicing is required when

the apparatus has been damaged in any

way, such as power-supply cord or plug

cord is damaged, liquid has been spilled

or objects have fallen into the apparatus,

the apparatus has been exposed to rain

or moisture, does not operate normally, or

has been dropped.

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

Modifications not expressly approved by the manufacturer could void

the user’s authority to operate the equipment under FCC rules.

Cet appariel numerique de la classe B respecte toutes les Exigences

du Reglement sur le materiel brouilleur du Canada.

What Ships in the Box

• Zone Mix 761 hardware device.

• Zone Mix 761 CD-ROM (Windows).

• One part number 12-0002-A switching

power supply which provides 24 VDC @

1.0 amperes. NOTE: This power supply

will accept a 100-240 VAC input.

• A North American (NEMA) or Euro IEC

power cable. You may need to substitute

a cable appropriate for your locale.

• 16 detachable 3.81 mm terminal block

connectors.

• This Quick Start Guide.

What You Need to Provide

• A Windows PC with 1 GHz or higher

processor and:

• Windows XP or higher.

• 250 MB free storage space.

• 1024x768 graphics capability.

• 16-bit or higher colors.

• CD-ROM drive or Internet connection.

• 512 MB or more of RAM as required by

your operating system.

• Network (Ethernet) interface.

• CAT5 cable or an existing Ethernet

network.

Getting Help

Zone Mix 761 software, the Windows

software that controls the hardware,

includes a help module which acts as a

complete User’s Guide for both hardware

and software. If you have questions

beyond the scope of this Quick Start

Guide, contact our Customer Support

Group in the following ways:

Tel: +1.425.778.7728

8:00 am to 4:30 pm

Monday through Friday,

Pacific Time

Web: http://www.symetrix.co

Email:

[email protected]

1 2 3 4

Summary of Contents

Page 1 - 8"3/*/(

1QUICK START GUIDE: Zone Mix 761SafetyG The lightning ﬂash with arrowhead symbol within an equilateral triangle is intended to alert the user of the

Page 2 - DANTE NETWORK AUDIO

2QUICK START GUIDE: Zone Mix 761Safety6408 216th Street SW | Mountlake Terrace, WA 98043 USAT +1.425.778.7728 F +1.425.778.7727 | www.symetrix.coThe

Page 3 - Declaration of Conformity

3QUICK START GUIDE: Zone Mix 761Declaration of Conformity6408 216th Street SW | Mountlake Terrace, WA 98043 USAT +1.425.778.7728 F +1.425.778.7727 |

Page 4 - Warranty and Service

4QUICK START GUIDE: Zone Mix 761Warranty and Service6408 216th Street SW | Mountlake Terrace, WA 98043 USAT +1.425.778.7728 F +1.425.778.7727 | www.

Comments to this Manuals

No comments

Symetrix Zone Mix 761 User Manual

Browse online or download User Manual for Computer hardware Symetrix Zone Mix 761. Symetrix Zone Mix 761 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Computer hardware Symetrix Zone Mix 761